First time w/clones

[Purpmonkey]

Today I built an aero cloner bucket:
5 gal bucket
submersible pump
about 3 foot of 1/2 inch PVC
two end caps
6 90 degree elbows
one male threaded female slide end
hand full of ez-sprayer heads
a little PVC glue
primer
holes in the lid for 2" baskets with the bottoms cut off
neoprene collars
viola a cloner.

I put my new cuttings in the cloner one is Harry Skywalker pheno 1 far left, Harry Skywalker pheno 2 far right, red dragon feminized center.

The brew consists of
2 gal R.O.
xtreme azos 1 tbls
rapid start .5

[SisterMaryElephant]

Nice; did you take pictures of the assembly? We can always use more step by step type tutorials too...

[Purpmonkey]

No step by step pictures, I just rough cut the PVC and used an exacto to cut the holes in the lid. I will put up a picture of the insides. Hardest part would have been the sprayer heads had I not have had a thread tap. Other than that it's all pretty cut and dry.

[Purpmonkey]

Cloner

image.jpg (145.32 KiB) Viewed 46019 times

image.jpg (234.14 KiB) Viewed 46019 times

[SisterMaryElephant]

Nice...

Make sure that the pressure isn't so high that it hurts the new roots.

[rkymtnman]

very nice. i love DIY.

i'd get a filter bag to protect the pump from anything getting into it and clogging up the sprayers. most aquarium suppliers have them. even some hydro shops

[SisterMaryElephant]

Yeah, that's a good idea too...

[Purpmonkey]

image.jpg (377.88 KiB) Viewed 46006 times

Update : added some new clones
Starting at the power cord going counter clockwise Harry skywalker pheno 1 , ultrasour , red dragon, blue og , Harry skywalker pheno 2

[GrowTutor]

If you click the "place inline" button for your attachments you get rid of that white border/box around the pictures.

[Purpmonkey]

So how long should clones take to root approximately? I'm not seeing any sign of roots so far at least.

I changed water and now there is 1 gal RO w/2 ml cal mag and 1 drop superthrive Phed to 5.8 temp is 65